• Ron
    Participant
    Post count: 2
    • Offline
    #1320 |

    I have a Toshiba 40BL702B which was fine until i unplugged it when I went on holiday, when I plugged it in again it stays completely dead no lights or anything, no attempt at startup, looking at this kit 29 it says it will only be successful if the Board fuse is still good but I don’t see a fuse on my panel to check, where is this fuse,

    thanks

  • tech support
    Keymaster
    Post count: 46
    • Offline
    #1321 |

    Hi Ron,

    the fuse you need to locate is next to the mains input board plug, it’s small round and red and has the board designation F100 and the value of 3.15 amp at 250 volt. you will need a multimeter to check the two solder connections on the underside of the Board to check if it has failed or not, I have attached an image of the fuse to help you locate it,

    regards,
    Tech Support

    Attachments:
    You must be logged in to view attached files.
  • Ron
    Participant
    Post count: 2
    • Offline
    #1471 |

    Thanks, my Fuse is OK so I have ordered the Repair Kit

    thanks,

    Ron

  • tech support
    Keymaster
    Post count: 46
    • Offline
    #1472 |

    Hi Ron,

    come back to this forum for support with the kit installation if you feel that you need it,

    Good Luck, Tech Support

You must be logged in to reply to this topic.